Building a sliding mount for my in car radio - Part 3

I have now soldered the two channels onto the brass base. I held the channels in place with some bent paperclips which actually did a very good job. I cleaned the brass and applied some flux before heating it. The solder ran smoothly between the parts and made good clean joints. The top part of the mount slides smoothly in the channels and should hold the radio securely to the underside of my dashboard. The next job is to clean up the brass and remove any flux and excess solder.

Paperclips did a good job of holding the parts

 

 

All the parts soldered in place

 

 The finished parts showing the top mount slid into place

Building a sliding mount for my in car radio - Part 2

The main part of the bracket has now been drilled and the holes countersunk. I cut down four screws and will be using both flat and crinkle washers. The preformed channels have had one end folded over and silver soldered. The next job is to clean up the brass and position the first channel ready for soldering. I plan to hold the channel in place with some bent paper clips. Hopefully this will do the job without the parts moving about. Once the first one has been soldered in position I’ll arrange the second channel so that the top part of the bracket slides in without binding. After both have been soldered I’ll have the fun of cleaning it all up.