Tuesday 30 April 2013

Building a sliding mount for my in car radio - Part 2


The main part of the bracket has now been drilled and the holes countersunk. I cut down four screws and will be using both flat and crinkle washers. The preformed channels have had one end folded over and silver soldered. The next job is to clean up the brass and position the first channel ready for soldering. I plan to hold the channel in place with some bent paper clips. Hopefully this will do the job without the parts moving about. Once the first one has been soldered in position I’ll arrange the second channel so that the top part of the bracket slides in without binding. After both have been soldered I’ll have the fun of cleaning it all up.

No comments:

Post a Comment